3D
Front
Hatch end
Top
Tap a piece in the model to see its size.
The 3D model couldn't load on this device. The steps and piece sizes on the right still work.
Back
Next
Step 1 of 12
The frame as it is now
Pieces in this step
Colour key
Main cut sizes, in mm
Piece Size
2 Floors890 × 852hen half 903 × 852run half, with a 540 × 18 notch for the mesh door 2 Door ledger strip500 × 20 × 18two layers of 9 mm ply, inside the front base rail 3 End wall860 × 913 3 Egg hatch (optional)650 × 340cut-out from the end wall, centred, bottom edge 100 up; ply stops 30 wide: 650, 340, 340 4 Back wall904 × 913 5 Top deck, hen half904 × 869cut 904 × 878, then trim 9 off the front edge 8 Gables878 long, 100 and 554 highcut both from an 878 × 657 strip, then trim 9 off the tall end of the hatch-end one 9 Roof front wall, run half899 × 549with a 250 × 300 feeder hole, 60 in from the run end, 150 up 9 Feeder slider300 × 360runs in ply runners: 2 × 610 × 20 and 2 × 610 × 40 12 Tall front door818 × 1468opens the coop and the roof storage 12 Hinge strip80 × 1471 12 Door ledges ×3785 × 100 ×2, 745 × 100each two layers of 9 mm ply Long palings: back rail, cleats, purlin 1794trim 6 off each Palings: rafter, sloping strips 925, 900cut to fit
Cutting plan, numbered by step
Pencil each number on the piece as you cut it. The number on a piece's left edge is its height as drawn, and the number along its bottom is its width. The dashed cut-away on the run floor is the notch for the mesh door. This step's pieces are highlighted. Tap a piece to jump to the step where it goes on.